LR3/Disco 3
Transceiver Module
Removal
Installation
Published : Nov 8, 2005
1 .
Remove the RH lower rear quarter trim panel. For additional information, refer to
Rear Quarter Trim
Panel (76.13.12)
(Section 501-05)
2 .
CAUTION: Cover fibre optic cable connectors to minimise dust ingress and avoid bending the
cables in a radius of less than 30 mm.
Remove the cellular phone module.
Remove the Torx bolt.
Disconnect the 2 electrical connectors.
1 .
Install the cellular phone module.
Connect the electrical connectors.
Tighten the Torx bolt to 10 Nm (7 lb.ft).
2 .
Install the RH lower rear quarter trim panel. For additional information, refer to
Rear Quarter Trim
Panel (76.13.12)
(Section 501-05)
3 .
Using WDS, configure a new module.