LR3/Disco 3
Fender Splash Shield (76.10.48)
Removal
Published : May 5, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the fender moulding. For additional information, refer to
Fender Moulding (76.43.54)
(Section 501-08)
3 .
Remove the fender splash shield.
Remove the 2 screws.
Remove the 6 retainers.
Disconnect the electrical connector.
4 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the tire pressure antenna.
Remove the 2 retainers.