LR3/Disco 3
Installation
5 .
NOTE :
Do not disassemble further if the component is removed for access only.
Release and remove the cable.
Release the clip.
1 .
Install the cable.
Secure the clip.
2 .
Install the solenoid.
Attach the cable.
Install the Torx screws.
3 .
Install the fuel filler flap latch assembly.
Connect and secure the electrical connector.
Carefully secure the clips.
4 .
Install the C-pillar lower trim panel. For additional information, refer to
C-Pillar Lower Trim Panel
(76.13.34)
(Section 501-05)
5 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)