LR3/Disco 3
6 .
NOTE :
Using a 13 mm Allen key, adjust the LH liftgate hinge until a profile of 2 mm below flush to the roof panel is achieved.
7 . Repeat the above procedure for the RH liftgate hinge.
8 . Check for correct operation of the liftgate, and if necessary adjust the liftgate and tailgate strikers.
9 . Install the rear headliner trim panel.
CAUTION: When setting the liftgate profile, make sure that the liftgate hinge NOT being adjusted has its
retaining bolt fitted.
Turning the Allen key clockwise will raise the liftgate.
Install the bolt and tighten to 40 Nm (30 lb.ft).
Connect the electrical connector.
Secure with the clips.
