LR3/Disco 3
B-Pillar Upper Trim Panel (76.13.28)
Removal
Installation
Published : Apr 28, 2004
1 .
Make the SRS system safe. For additional information, refer to
Standard Workshop Practices
(Section 100-00)
2 .
Remove the B-pillar lower trim panel. For additional information, refer to
B-Pillar Lower Trim Panel
(76.13.29)
(Section 501-05)
3 .
Release the safety belt lower anchor from the seat.
Remove the bolt cover.
Passenger side, disconnect the electrical connector.
Remove the Torx bolt.
4 .
NOTE :
Make sure the seat belt height adjuster is at its lowest point prior to removal of the B-pillar upper trim
panel.
Remove the B-pillar upper trim panel.
Release the front and rear door weatherstrips for access.
Release the 2 lower clips, then the remaining upper clip.
Release the safety belt.
1 .
Install the B-pillar upper trim panel.