LR3/Disco 3
two seconds
Operate the drivers window switch until the window is in the fully open position (one-shot down)
NOTE :
Operate the drivers window switch once to the close position.
Driver's Door Anti-trap Regulator Pin Out Information
Connector C0740
WINDOW CONTROL DIAGRAM
NOTE :
If the drivers window motor initialisation has been completed correctly, when the drivers window switch is operated,
the window should move to the fully closed position (one-shot up) automatically. If the window does not fully close
automatically (one-shot up), repeat the complete procedure.
Pin No. Description Input/Output
1
Up signal
Input
2
Down signal
Input
3
Battery supply
Input
4
Ground
-
5
Not used
-
6
Enable line
Input
A = Hardwired