LR3/Disco 3
Rear Door Window Glass (76.31.02)
Removal
NOTE :
NOTE :
Installation
Published : Jun 17, 2004
Once the rear door window fixed glass has been removed the rear door glass can be simply lifted and removed
from the door.
The door glass should be lowered by approximately one third.
1 .
Remove the rear door window fixed glass. For additional information, refer to
Rear Door Fixed
Window Glass (76.31.31)
(Section 501-11)
2 .
Remove the rear door window glass.
3 .
NOTE :
Do not disassemble further if the component is removed for access only.
NOTE :
Note the fitted position.
Remove the glass retaining clip.
Remove the Torx bolt.
Remove the spacer washer.
Remove the flat washer.
1 .
Install the glass retaining clip.
Install the spacer.
Install the washer.
Tighten the Torx screws to 8 Nm (6 lb.ft).
2 .
Install the rear door window glass.
3 .
Install the rear door window fixed glass. For additional information, refer to
Rear Door Fixed Window
Glass (76.31.31)
(Section 501-11)