LR3/Disco 3
Headlamp Washer Pump (84.20.21)
Removal
Installation
Published : Apr 6, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the LH fender splash shield. For additional information, refer to
Fender Splash Shield
(76.10.48)
(Section 501-02)
3 .
Release the headlamp washer pump hose.
Drain the washer reservoir fluid.
4 .
Disconnect the headlamp washer pump electrical connector.
5 .
Remove the headlamp washer pump.
Discard the O-ring seal.
1 .
Install the headlamp washer pump.
Install a new O-ring seal.
2 .
Connect the headlamp washer pump electrical connector.
3 .
Connect the headlamp washer pump hose.
4 .
Install the fender splash shield. For additional information, refer to
Fender Splash Shield (76.10.48)
(Section 501-02)
5 .
Lower the vehicle.
6 .
Top-up the windshield washer reservoir.