LR3/Disco 3
Windshield Wiper Motor (84.15.12)
Removal
Installation
Published : Jul 1, 2004
1 .
Remove the plenum chamber panel. For additional information, refer to
Plenum Chamber (80.15.62)
(Section 412-01)
2 .
Remove the windshield wiper motor and linkage.
Remove the 2 bolts.
Remove the 2 clips.
Disconnect the electrical connector.
3 .
NOTE :
Do not disassemble further if the component is removed for access only.
Noting the fitted position, remove the wiper linkage.
Remove the 2 bolts.
Remove the nut.
1 .
Install the wiper linkage.
Tighten the bolts to 10 Nm (7 lb.ft).
Tighten the nut to 25 Nm (18 lb.ft).
2 .
CAUTION: Make sure the windshield wiper motor is located on its stud prior to installing the