LR3/Disco 3
3 .
With assistance, install the roof opening panel assembly.
Clean the component mating faces.
Tighten the bolts to 10 Nm (7 lb.ft).
4 .
Connect the roof opening panel motor electrical connector.
5 .
Connect the drain hoses.
Make sure the drain hoses are clear prior to connection.
6 .
Install the headliner. For additional information, refer to
Headliner (76.64.15)
(Section 501-05 Interior
Trim and Ornamentation)
7 .
Using T4, configure a new roof opening panel.
8 .
If the battery has been disconnected, the one touch and anti-trap function will become inoperative.
Close the roof opening panel and continue to hold the switch for a further 20 seconds to allow the
sunroof to complete a full cycle. This will complete the roof opening panels calibration routine and
reset these functions.