LR3/Disco 3
Fender Apron Panel Reinforcement
Removal
NOTE :
Published : Sep 16, 2004
In this procedure the fender apron panel reinforcement is replaced in conjunction with fender apron panel closing.
1 .
Disconnect both the battery cables. For additional information, refer to
Specifications
(Section 414-
00 )
2 .
Remove the front fender. For additional information, refer to
Fender (76.10.24)
(Section 501-02 )
3 .
Remove the hood latch panel. For additional information, refer to
Hood Latch Panel (76.16.22)
(Section 501-27 )
4 .
L/H side: Remove the battery junction box. For additional information, refer to
Battery Junction Box
(BJB) - 2.7L Diesel (86.70.55)
(Section 418-00 Module Communications Network)
5 .
L/H side: Remove the power steering fluid reservoir. For additional information, refer to
Power
Steering Fluid Reservoir - 2.7L Diesel (57.15.08)
(Section 211-02 )
6 .
L/H side: Remove the battery.
7 .
L/H side: Remove the fuel fired booster heater. For additional information, refer to
Fuel Fired Booster
Heater (80.40.01)
(Section 412-02B Auxiliary Heating)
8 .
L/H side: Remove fuel fired booster heater pipes.
9 .
R/H side: Remove the air cleaner. For additional information, refer to
Air Cleaner (19.10.01)
(Section
303-12C )
10 .
R/H side: Release the ABS modulator.
11 .
Remove the wiring harness.
12 .
Remove the plenum chamber panel. For additional information, refer to
Plenum Chamber
(80.15.62)
(Section 412-01 Air Distribution and Filtering)
13 .
Remove the hood.
14 .
Remove both hood support struts.
15 .
Remove the hood wiring harness.
16 .
Item
Description
1
Acoustic seal.