LR3/Disco 3
Rear Floor Panel Section (77.70.02)
Removal
NOTE :
Installation
Published : Sep 16, 2004
In this procdure, the rear floor panel section is replaced in conjunction with the back panel and rear crossmember.
1 .
Disconnect both battery cables. For additional information, refer to
Specifications
(Section 414-00
Charging System - General Information)
2 .
Remove the back panel. For additional information, refer to
Back Panel (77.80.20)
(Section 501-30
Rear End Sheet Metal Repairs)
3 .
Remove the rear crossmember. For additional information, refer to
Rear Crossmember
(Section
501-30 Rear End Sheet Metal Repairs)
4 .
Item
Description
1
Mig-weld.
2
Mig-weld.
3
Mig-welds and 18 plug-welds.
5 .
For additional information:
Welding. For additional information, refer to
Body Repairs
(Section 501-25A Body Repairs
- General Information)
Corrosion protection. For additional information, refer to
Corrosion Protection
(Section
501-25B Body Repairs - Corrosion Protection)
Tolerance checks. For additional information, refer to
Body and Frame
(Section 501-26
Body Repairs - Vehicle Specific Information and Tolerance Checks)
1 .
Install is the reversal of removal.