LR3 (LA) V6-4.0L (2006)
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
Normal warranty policy and procedures apply.
REPAIR PROCEDURE
REPLACE PARKING AID CONTROL MODULE
NOTE:
Global Technical Reference (GTR) lookup sequence is as follows:
GTR Home > NAS > Service Information/ LA - LR3/2005 > Discovery 3/LR3 2005 Workshop Manual > Bookmark "Electrical/Battery and
Charging System/414-00: Charging System - General Information" > Link "Specifications"
1.
Refer to LR3 Workshop Manual Section 414-00 and disconnect the battery ground cable.
NOTE:
Global Technical Reference (GTR) lookup sequence is as follows:
GTR Home > NAS > Service Information/ LA - LR3/2005 > Discovery 3/LR3 2005 Workshop Manual > Bookmark "Body and Paint/501-05:
Interior Trim and Ornamentation" > Link "C-Pillar Lower Trim Panel"
2.
Refer to LR3 Workshop Manual Section 501-05 and remove the left side C-pillar lower trim panel.
3.
Remove the parking aid module as follows:
(Figures 1 and 2)
^
Remove the two retaining nuts.
^
Disconnect the three electrical connectors.
4.
Replace the parking aid module with a new unit as follows:
^
Connect and secure the electrical connectors to the new unit.
^
Tighten the retaining nuts to 5 Nm (4 lbf-ft).
5.
Refer to LR3 Workshop Manual Section 414-00 and install the C-pillar lower trim panel.