LR3 (LA) V6-4.0L (2006)
11.
Install the new DVD interface module (VUB503990). (Figure 10)
12.
Secure the wiring harness.
13.
Secure the white electrical connector to the mounting bracket.
14.
Secure the DVD interface module to the mounting bracket.
15.
Where installed, connect the rear A/C control electrical connectors.
16.
Connect the electrical connectors.
17.
Connect the ground connection and position the DVD unit.
NOTE:
Tightening the retaining screws evenly to the correct torque is important for the correct operation of the DVD display unit.
18.
Install the four retaining screws and tighten to 5-7 Nm (3.7-5.2 lbf-ft).
19.
Install the four retaining screw covers.
20.
Refer to the GTR section 414-00 and connect the vehicle battery.
Disclaimer