LR3 (LA) V6-4.0L (2006)
Memory Positioning Module: Customer Interest
Mirrors - Don't Move in the Anticipated Directions
No.: LTB00042
Issue: 2
Date: 14 April 2008
ISSUE "2" CHANGES ARE HIGHLIGHTED WITH GRAY BACKGROUNDS AND SHOWN WITH ASTERISKS.
SECTION: 501-00
Automatic Side Mirror Dipping Feature - Repair Procedure
AFFECTED VEHICLE RANGE
CONDITION SUMMARY:
MIRROR DOES NOT MOVE IN ANTICIPATED PATTERNS
*NOTE:
REFER TO SPECIAL SERVICE MESSAGE (SSM) 33984 FOR A CUSTOMER CONCERN OF THE MIRRORS MOVING UPWARDS WHEN
REVERSE GEAR IS SELECTED. DO NOT FOLLOW THE REPAIR PROCEDURE OUTLINED IN THIS BULLETIN.*
Situation:
Some sequences of ignition cycles/gear positions (involving reverse) can cause the control software within the driver's seat module to become confused
and lose the mirror memory position or learn an incorrect driving position. A customer may complain of any of the following conditions:
^
Memory mirrors are in the incorrect position after unlocking and entering the vehicle.
^
Memory mirrors are not returning to their correct driving position after a reverse maneuver has been completed and the gear selector has been moved
out of reverse.
^
On vehicles with the 'Lazy Entry' feature enabled, the following sequence will result in the mirrors incorrectly moving to the dipped position:
>
Ignition 'ON'.
>
Select reverse gear - mirrors move to dipped position.
>
Ignition 'ON' - auxiliary.
>
De-select reverse gear - mirrors move to driving position.
>
Lock the vehicle.
>
Unlock the vehicle - mirrors move to the dipped position (INCORRECT).
^
On vehicles with the 'Lazy Entry' feature enabled, the normal driving position may drift if the following sequence is repeated for a number of cycles:
>
Ignition 'ON'.
>
Select reverse gear (mirrors move to dipped position).
>
De-select reverse gear (mirrors move to driving position).
>
Ignition 'ON' - auxiliary - key-in - key-out.
>
Lock the vehicle.