LR3 (LA) V6-4.0L (2006)
Installation
1. Connect the door exterior handle mechanism cable to the door latch.
^
Connect the cable to the lever.
^
Secure the cable to the abutment bracket.
2. Install the remote control cable to the door latch.
^
Connect the cable to the lever.
^
Secure the cable to the abutment bracket.
3. Set the exterior handle mechanism.
^
Rotate the lever.
^
Engage the retaining tang.
4. Install the rear door latch assembly.
^
Tighten the Torx screws to 10 Nm (7 lb.ft).
^
Connect the electrical connector.
5. Install the door exterior handle mechanism.
^
Position the mechanism to the door.
^
Fit the locking pin.
^
Install and tighten the Torx screws.
6. Position the remote control cable to the door.
^
Install the grommet.
7. Install the rear door exterior handle.
8. Install the rear door window motor and regulator assembly.