LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-2474004.png)
Installation
1. Install the horn assemblies.
^
Install the air deflectors.
^
Install the bolts and tighten to 10 Nm (7 lb.ft).
2. Install the LH hood latch.
^
Tighten the Torx bolts to 10 Nm (7 lb.ft).
3. Install the RH hood latch.
^
Attach the hood release cable.
^
Install the hood switch.
^
Tighten the Torx bolts to 10 Nm (7 lb.ft).
4. Install the spacers.
^
Install the clips.
5. NOTE: Align to the position noted on removal.
With assistance, install the hood latch panel.
6. Install the panel fixings.
^
Install and tighten the bolts to 25 Nm (18 lb.ft).
7. NOTE: Align to the position noted on removal.
Install the wiring harness.
^
Connect and secure the electrical connector.
^
Carefully secure the clips.
8. Connect the hood release cable.
9. Install the radiator securing pegs.
10. Install the coolant expansion tank.
^
Position the coolant expansion tank, locate the spigot and lug.
^
Install the bolts and tighten to 10 Nm (7 lb.ft).
11. Install the windshield washer reservoir filler neck.
^
Locate in clip.
12. Install the power steering fluid reservoir.
^
Position and secure to mounting bracket.
13. Install the front bumper.
14. Open and close the hood to check the hood latch operation.
15. Adjust both of the hood latches.
^
Loosen the 4 hood latch Torx bolts.
^
Lower the hood and check for alignment.
^
Open the hood and tighten the Torx bolts to 10 Nm (7 lb.ft).
^
Check for the correct operation of the hood safety catch.
^
If necessary, repeat the above adjustment procedure.
