LR3 (LA) V6-4.0L (2006)
Sunroof / Moonroof Panel: Service and Repair
Glass Roof Panel
Glass Roof Panel
Service Repair No - 76.81.05
Removal
CAUTION:
^
Always protect paintwork and glass when removing exterior components.
^
Always protect the interior components when removing body glass.
^
Lay the glass on felt covered supports. Do not stand on edge as this can cause chips which subsequently develop into cracks.
NOTE: The following equipment is required: / Cutting wire and handles / Kent knife / Glazing knife / Glass replacement kit / Sealant applicator gun /
Suction cups / A felt covered table or stand to support glass.
1. Remove the headliner.
2. Remove the roof moulding.
^
Release the 3 clips.
^
Repeat the above procedure for the other side.
3. Remove the antenna.
^
Disconnect the cable.
^
Remove the 2 screws.
4. WARNING: Eye protection must be worn.
With assistance, remove the roof panel fixed glass.
^
Carefully cut through the sealant using a glazing knife or cutting wire.
^
Attach the suction cups.
^
Noting fitted position, remove the 11 spacers.