LR3 (LA) V6-4.0L (2006)
1. NOTE: Due to the gear ratio, it may be necessary to rotate the balance shaft up to 7 complete turns to find the correct position.
Align the balance shaft.
^
Clean the components.
^
Lubricate the components.
^
Install a 4 mm (0.16 inch) pinto lock the shaft as shown.
2. Rotate crankshaft clockwise until number one cylinder is at TDC and install the special tool.
3. Install the balance shaft.
^
Clean the component mating faces.
^
Engage the drive chain.
^
Install the drive chain tensioner.
^
Tighten the new Torx bolts to 29 Nm (21 ft. lbs.)
^
Remove the locking pin.
^
Remove the special tool.
4. Install the cylinder block cradle.
5. Install the front wheels and tires.
6. Connect the battery ground cable.