LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-1956005.png)
^
Remove the 2 Torx screws.
5. Remove the temperature blend door actuator.
^
Disconnect the electrical connector.
^
Remove the 2 screws.
Installation
1. Install the temperature blend door actuator.
^
Tighten the screws.
^
Connect the electrical connector.
2. Install the passenger side footwell duct elbow.
^
Tighten the screws.
3. Install the passenger side footwell duct.
^
Install the clip.
4. Install the passenger side closing trim panel.
^
Install the interior lamp.
^
Connect the electrical connector.
^
Secure the clip.
5. Install the glove compartment.
Instrument Panel Blend Door Actuator - LHD
Instrument Panel Blend Door Actuator - LHD
Removal
1. Remove the instrument panel driver side reinforcement.
2. Remove the driver side footwell duct.
^
Remove the 2 Torx screws.
