LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-2002007.png)
^
Tighten the Torx screws.
8. Connect the drain tubes to the heater housing.
9. Install the adaptor panels.
^
Tighten the nuts to 6 Nm (4 ft. lbs.).
10. Secure the A/C lines to the bulkhead.
^
Clean the components.
^
Install new O-ring seals.
^
Tighten the bolt to 6 Nm (4 ft. lbs.).
11. Secure the A/C lines to the body.
^
Tighten the nut to 6 Nm (4 ft. lbs.).
12. Connect the bulkhead heater hoses.
13. With assistance, install the instrument panel.
^
Tighten the Torx bolts to 25 Nm (18 ft. lbs.).
14. Install the instrument panel carrier to bulkhead Torx bolt and tighten to 25 Nm (18 ft. lbs.).
15. Install the plenum chamber panel.
16. Secure the heater housing.
^
Tighten the screws.
17. Connect the steering column intermediate shaft.
^
Install the special bolt and tighten the new nut to 22 Nm (16 ft. lbs.).
18. Install the heater housing center ducts.
19. Connect the instrument panel center reinforcement fibre optic cables.
20. Connect the instrument panel center reinforcement electrical connectors.
21. Connect the CJB electrical connectors.
22. Connect the heater motor electrical connector.
23. Connect the electrical connectors to the passenger side lower A-pillar.
24. Connect the ground cables to the passenger side lower A-pillar.
^
Tighten the nuts to 10 Nm (7 ft. lbs.).
25. Connect the electrical connectors to the driver side lower A-pillar.
26. Connect the ground cables to the driver side lower A-pillar.
^
Tighten the nuts to 10 Nm (7 ft. lbs.).
27. Install the instrument panel upper section.
28. Install the front seat.
29. Recharge the A/C system.
30. Refill the cooling system.
31. Install the intake manifold.
