landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Steering/Suspension - Tires Wearing Unevenly|Page 1974 > < Steering/Suspension - Tires Wearing Unevenly|Page 1972
Page 14
background image

NOTE:

A small number of coil sprung vehicles were imported into North America at the very start of LR3 importation. Step 2 is included in the event
that such a vehicle requires suspension alignment.

2.

If the vehicle has coil spring suspension, perform the following steps to ensure that the equivalent of a full tank of gasoline weight is present in the
vehicle when the alignment process is performed:

NOTE:

LR3 fuel tank capacity is 22.7 US gallons (86.3 liters). A full LR3 fuel tank weighs approximately 152 lbs (69 kg).

^

Accurately determine the volume of fuel in the tank.

^

If the tank is not full, calculate the weight of the fuel in the tank using one of the following formulas:

^

Multiply the number of US gallons of fuel by 6.7 to equal total pounds of fuel.

^

Multiply the number of liters of fuel by 0.8 to equal total kg of fuel.

NOTE:

Any weight equivalent placed into the load space area must be evenly distributed at the front and the right hand side of the load space.

^

Calculate the weight equivalent that must be added to the load space area by subtracting the total amount of fuel currently in the tank from
the LR3 fuel tank capacity of 152 lbs. (69 kg).

NOTE:

Vehicles that have any of the front or rear, upper or lower control arm bushings changed must complete a ten mile road test before having the
geometry checked and adjusted if necessary. The road test will allow the suspension to settle.

NOTE:

GTR lookup sequence is as follows:

GTR Home> NAS > Service Information/ LA - LR3 > Workshop Manuals> Bookmark "Chassis/Suspension/204-00: Suspension System -
General Information" Link "Four-Wheel Alignment (57.65.04)"

CAUTION:

GTR identifies an alignment specification range.

The exact "TARGET SPECIFICATIONS" in the table shown should be used on vehicles that have experienced uneven tire wear.

When setting suspension geometry after front or rear/upper or lower control arm bushing replacement, the rear toe should be set to the
TARGET SPECIFICATION in the table.

3.

Refer to GTR section 204-00 Four-Wheel Alignment operation 57.65.04 and adjust the front and rear wheel alignment to the TARGET
specification figures noted in the table.

Steering/Suspension - Tires Wearing Unevenly|Page 1974 > < Steering/Suspension - Tires Wearing Unevenly|Page 1972