LR3 (LA) V6-4.0L (2006)
Canister Purge Control Valve: Service and Repair
Evaporative Emission Canister Purge Valve
Service Repair No - 17.15.39
Removal
1. Disconnect the battery ground cable.
2. Remove the intake manifold casting.
NOTE: Note the fitted position.
3. Release the purge valve from the mounting bracket.
^
Remove the bolt.
CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open connections
to prevent contamination.
4. Remove the purge valve.
^
Disconnect the 2 hoses.
^
Disconnect the electrical connector.
Installation
1. Connect the purge valve.
^
Connect the hoses.
^
Connect and secure the electrical connector.
NOTE: Align to the position noted on removal.
2. Install the purge valve, align the peg and tighten the bolt to 6 Nm (4 ft. lbs.).
3. Install the intake manifold casting
4. Connect the battery ground cable.