LR3 (LA) V6-4.0L (2006)
Instrument Panel Control Module: Technical Service Bulletins
Instruments - Instrument Cluster Software Upgrade
No.: LA-413-002
Issue: 1
Date: April 04, 2006
SECTION: 413-08
Updating Instrument Cluster Software
AFFECTED VEHICLE RANGE:
Land Rover LR3 (LA)
VIN: 5A000360 to 6A372000
CONDITION SUMMARY:
INFORMATION SYMBOL PERMANENTLY DISPLAYED ON MESSAGE CENTER
NOTE:
When updating the instrument cluster software the air suspension control module software should be updated.
The Information symbol 'i' may be displayed on the message center following an instrument cluster software update using the Worldwide Diagnostic
System (WDS).
Cause:
The instrument cluster software level and the air suspension control module software level are incompatible. This causes the Information symbol 'i' to
display on the message center. The 'i' symbol can not be cleared using the turn-signal stalk 'i' button.
Action:
Should the Information symbol 'i' be displayed on the message center following an instrument cluster software update, refer to the Repair Procedure in
this bulletin to update the ride level control module software.
PARTS:
No parts. Software update notification only.
TOOLS:
LRCD13..........WDS CD 13 or later
WARRANTY:
Normal warranty policy and procedures apply.
REPAIR PROCEDURE
UPDATE RIDE LEVEL CONTROL MODULE SOFTWARE
CAUTION:
Connect a suitable battery charger to the vehicle during diagnostic procedure to prevent loss of battery charge or malfunction of electronic
control modules.
1.
Connect diagnostic equipment and begin a WDS session.
2.
Update ride level control module software to the latest level.
3.
Exit WDS session and disconnect diagnostic equipment from vehicle.