LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-95013.png)
^
Secure the clips.
^
Tighten the nuts to 25 Nm (18 ft. lbs.).
18. LH side: Connect the ABS electrical connector.
19. LH side: Attach the air suspension pipes.
^
Secure the clips.
20. LH side: Attach the body panel ground cables.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
21. LH side: Connect the body panel electrical connectors.
Vehicles with auxiliary climate control
1. LH side: Secure the A/C lines to the body panel.
^
Tighten the nut to 10 Nm (7 ft. lbs.).
All vehicles
1. LH side: Connect the adaptive front lighting control module electrical connector.
2. LH side: Connect the washer jet hose.
3. Passenger side: Connect the transfer case electrical connector.
4. Passenger side: Connect the engine wiring harness electrical connector.
5. Install the headlamps.
6. Install the fender splash shields.
7. Attach the BJB wiring harness to the bulkhead.
^
Connect the electrical connectors.
^
Install the grommet.
8. Install the battery ground cable.
^
Attach the additional ground cable.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
9. Secure the BJB to the bracket.
^
Tighten the bolt to 6 Nm (4 ft. lbs.).
10. Connect the heater motor electrical connector.
11. Connect the ground cables to the lower A-pillar.
^
Tighten the nut to 10 Nm (7 ft. lbs.).
12. Install the CJB bracket.
^
Tighten the nuts to 10 Nm (7 ft. lbs.).
^
Secure the clips.
^
Connect the electrical connectors.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
13. Install the CJB.
14. Connect the battery positive cable to the BJB.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
15. Install the BJB cover.
^
Secure the clip.
16. Install the ECM.
^
Install the ECM top cover.
17. Install the ECM cover.
^
Tighten the Torx screws.
^
Connect the electrical connectors.
18. Install the auxiliary battery tray.
19. Install the battery tray.
20. Install the four-wheel drive control module.
21. Install the air cleaner assembly.
22. Install the radiator grille.
23. Install the ignition coils.
24. Connect the battery ground cable.
25. Check the headlamp beam alignment.
