LR3 (LA) V6-4.0L (2006)
2.
Log on to GTR from an internet connected PC and download the WDS software patch installation help file as follows:
^
Select 'Home' from the menu at the top of the main page.
^
From the menus on the left of the page, select 'Diagnostics' as the 'Information Type' and select the relevant model and model year.
^
From the 'All Information' results, select 'Patch Files'.
^
Click the file link 'Patch Process Help File'.
NOTE:
This could take up to twenty minutes to download dependent on connection speed.
3.
Using the help file as a guide, follow the instructions to download and save WDS CD13 - Patch File
4.
Install the software patch file 'WDS CD13 - Patch File 3' into T4/ WDS and verify that WDS successfully restarts.
NOTE:
Midronics battery charger PSC550 must be connected to the vehicle battery during diagnosis/module configuration.
5.
Connect the diagnostic equipment to the vehicle and begin a WDS or IDS session.
6.
Note the current software levels of the engine control module as shown.
NOTE:
During module configuration, the on-screen software part number information that WDS/IDS will display can be checked and compared to the
software part number noted in step 4 above. If the same tune level is displayed, the vehicle already has the desired software level and the tune
download process can be aborted.
7.
Configure the control module:
^
Return to the 'Vehicle Configuration' screen and select 'Module Configuration'
^
Select 'Configure Existing Modules'.
^
From the sub-menu, select 'Engine Control Module'
^
Check the tick-box to continue and follow the on-screen instructions.
^
Compare the on-screen software part number information that WDS/IDS will display with the software part number noted in step 4 above.
^
If the same tune level is displayed, terminate the tune download.
NOTE:
Software levels should be as shown, or later.
8.
Repeat step 6 to confirm the software level change.
9.
Exit the WDS session and disconnect the diagnostic equipment from the vehicle.