LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-1750001.png)
Power Steering Pump: Service and Repair
Power Steering Pump - 4.OL
Service Repair No - 57.20.14
Removal
1. Disconnect the battery ground cable.
2. Remove the accessory drive belt.
3. CAUTION: Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any open
connections to prevent contamination.
NOTE: Some oil spillage is inevitable during this operation.
Clamp the power steering pump supply hose to minimize fluid loss.
4. Disconnect the high pressure line at the steering pump union.
^
Position an absorbent cloth to collect fluid spillage.
5. Disconnect the power steering pump supply hose.
^
Release the clip.
6. Remove the power steering pump.
^
Remove the 3 bolts.
Installation
1. Install the power steering pump.
^
Clean the component mating faces.
^
Install and tighten the bolts to 25 Nm (18 ft. lbs.).
2. Connect the power steering supply hose to the steering pump.
^
Clean the component mating faces.
^
Secure with the clip.
3. Connect the high pressure line to the steering pump.
^
Clean the component mating faces.
^
Install new seals.
^
Tighten the union to 25 Nm (18 ft. lbs.).
4. Install the accessory drive belt.
5. Connect the battery ground cable.
6. Fill and bleed the power steering system.
