LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-1794007.png)
Special Service Tools
Removal
NOTE: The bushings must be replaced in pairs, LH and RH sides.
NOTE: Take note of the fitted position of the bush.
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the wheels and tires.
3. Remove the RH lower arm.
4. Remove the halfshaft retaining nut.
^
Discard the nut.
5. CAUTION: Use a wrench on the hexagon provided to prevent the ball joint rotating.
Disconnect the LH stabilizer bar link.
^
Remove and discard the nut.
