LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-1798004.png)
18. Remove the wheel hub.
^
Remove the 4 bolts.
Installation
1. Clean the components.
2. Install the wheel hub.
^
Tighten the 4 bolts to 115 Nm (85 ft. lbs.).
3. Install the brake disc dust shield.
^
Tighten the 5 bolts to 10 Nm (7 ft. lbs.).
4. CAUTION: The lower arm ball joint can be damaged by excessive articulation. The wheel knuckle must be fully supported at all times. Do not
allow the wheel knuckle to hang on the lower arm. Failure to follow this instruction will result in damage to vehicle.
With assistance, install the wheel knuckle.
5. Using the special tools, install the halfshaft in the wheel hub.
6. Connect the upper arm and wheel knuckle.
^
Install a new nut and tighten to 70 Nm (52 ft. lbs.).
7. Secure the stabilizer bar link.
^
Install a new nut and tighten to 115 Nm (85 ft. lbs.).
8. Tighten the lower arm ball joint retaining nut to 115 Nm (85 ft. lbs.).
9. Connect the tie-rod end ball joint.
^
Install a new nut and tighten to 70 Nm (52 ft. lbs.).
10. Install a new halfshaft retaining nut and lightly tighten.
11. Install the wheel speed sensor.
^
Tighten the bolt to 10 Nm (7 ft. lbs.).
12. Install the brake disc.
13. Tighten the new halfshaft retaining nut to 350 Nm (258 ft. lbs.).
^
Stake the nut to the halfshaft.
14. Install the wheel and tire.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
