LR3 (LA) V6-4.0L (2006)
2. Remove the bracket from the new ride height sensor: (Figure 4)
^
Remove the two screws. Discard the bracket.
CAUTION:
Failure to follow this instruction may result in damage to the vehicle.
NOTE:
If the sensors are fitted in the incorrect position the vehicle will sit on the bump stops and not calibrate.
NOTE:
Verify parts to ensure correct sensors are fitted to the correct position on the vehicle.
3. Refer to Workshop Manual, section 204-05: Vehicle Dynamic Suspension > Removal and Installation > Suspension Height Sensor (60.36.01), and
replace the height sensor.
NOTE:
Range Rover Sport only: