LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-1251003.png)
1. CAUTION: Make sure that when fully fitted, all seals protrude by the same amount.
CAUTION: Engage the selector lever with the groove in the piston rod.
Install the valve body.
^
Clean the component mating faces.
^
Install new seals.
^
Install a new seal block.
^
Tighten the Torx screws to 8 Nm (6 ft. lbs.).
2. Install a new electrical connector sleeve.
^
Secure with retainer.
3. Connect the electrical connector.
4. Install the fluid pan.
5. Calibrate a new main control valve body using T4.
