LR3 (LA) V6-4.0L (2006)
1. Using the special tools, install the axle housing bushing.
2. CAUTION: Make sure the weight of the axle is always supported.
Using a suitable jack, raise the front of the differential.
^
Install the axle front retaining bolt.
^
Tighten to 275 Nm (203 ft. lbs.).
3. Attach the driveshaft to the rear axle drive flange.
^
Clean the component mating faces.
^
Attach the driveshaft to the rear axle drive flange.
^
Tighten the new Torx bolts to 150 Nm (110 ft. lbs.).
4. Install the fuel tank heat shield.
^
Tighten the bolts and nuts to 10 Nm (7 ft. lbs.).
5. Install the muffler assembly.
Rear Axle Housing Support Insulator
Rear Axle Housing Support Insulator
Service Repair No - 51.15.44