LR3 (LA) V8-4.4L (2009)
6. Remove the RH tail pipe.
^
Using 100-051, cut the tail pipe at the point indicated by a depression in the pipe.
Installation
1. NOTE: Do not tighten the retaining clamp at this stage.
Position the RH tail pipe to the muffler assembly.
^
Clean the components.
^
Install the retaining clamp.
2. NOTE: Do not tighten the retaining clamp at this stage.
Position the LH tail pipe to the muffler assembly.
^
Clean the components.
^
Install the retaining clamp.
3. With assistance, install the muffler assembly.
^
Attach the exhaust hangers.
^
Install a new gasket.
^
Tighten the catalytic converter nuts and clamp to 48 Nm (35 ft. lbs.).
4. Align both tail pipes and tighten the retaining clamps to 55 Nm (40 ft. lbs.).