Land Rover Workshop Manuals
LR3 (LA) V8-4394cc 4.4L (2005)
Engine, Cooling and Exhaust > Cooling System > Coolant Level Sensor > Component Information > Technical Service Bulletins > All Other Service Bulletins for Coolant Level Sensor: > TECLA204003 > May > 06 > Air Suspension - Height Sensor Connector Overlay Harness > Page 2953
Remove approximately 10 mm (0.40 in) of insulation from the overlay harness wire. (Figure 5)
Crimp the open end of the Butt Splice connector to the corresponding overlay harness wire.
Ensure both wires are securely crimped to the Buff Splice connector.
When using the heat gun, care must be taken to avoid damage to surrounding areas.
Slide the 'heatshrink' sleeve over the Buff Splice connector.
|[PREV PAGE] [NEXT PAGE]|