LR3 (LA) V8-4394cc 4.4L (2005)
/v8-4394cc_4.4l/Page-680003.png)
16. Remove the engine front mount.
^
Remove and discard the 2 bolts.
Installation
1. Clean the component mating faces.
2. Install the engine front mount.
^
Tighten the bolts to 45 Nm (33 ft. lbs.), then a further 60 degrees.
3. Lower the engine onto the mount.
^
Tighten the nut to 90 Nm (66 ft. lbs.).
4. Remove the engine support.
5. Install the steering column lower universal joint assembly.
^
Install new patch lock bolts and tighten to 25 Nm (18 ft. lbs.).
6. Secure the brake hose to the upper arm.
^
Tighten the bolt to 23 Nm (17 ft. lbs.).
7. Connect the upper arm and wheel knuckle.
^
Remove the cable tie securing the upper arm.
^
Install a new nut and tighten to 70 Nm (52 ft. lbs.).
8. Secure the stabilizer bar link.
^
Tighten the nut to 115 Nm (85 ft. lbs.).
9. Connect the height sensor link arm.
10. Install the upper suspension arm and brake line heat shields.
^
Install the bolts.
^
Install the nuts.
11. Install the engine compartment upper LH heat shield.
^
Install the screw.
12. Install the engine undershield.
13. Install the front wheel.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
