LR3 (LA) V8-4394cc 4.4L (2005)
/v8-4394cc_4.4l/Page-527004.png)
14. Adjust the front toe.
^
Loosen the track rod end locking nuts.
^
Rotate the track rods to adjust each individual front toe to the correct value.
^
Tighten the track rod end locking nuts to 53 Nm (39 ft. lbs.).
15. Vehicles with dynamic suspension: Using the diagnostic equiptment, return the vehicle to "Normal Mode".
^
Select the "Configuration" tab.
^
Select "Set up and Configure"
^
Select "Air Suspension".
^
Select "Suspension Geometry Set Up".
^
Select "Normal Mode".
^
Follow the on-screen instructions until the normal mode process has finished.
16. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
18. Remove the rear wheels and tires.
19. Tighten the rear camber adjusting bolts to 133 Nm (98 ft. lbs.).
20. Install the wheels and tires.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
21. Calibrate the steering angle sensor using approved Land Rover diagnostic equiptment.