LR3 (LA) V8-4394cc 4.4L (2005)
/v8-4394cc_4.4l/Page-97013.png)
9. Connect the brake booster vacuum pump electrical connector.
10. Attach the hood wiring harness.
^
Install the grommet.
^
Install the cover.
^
Secure with the clips.
^
Connect the electrical connectors.
^
Connect the washer jet hoses.
11. Install the hood pad.
^
Install the clips.
12. Install the windshield wiper motor.
13. LH side: Attach the wiring harness.
^
Install the grommet.
^
Secure the clips.
14. LH side: Connect the brake pad wear sensor electrical connector.
15. LH side: Connect the coolant expansion tank level switch electrical connector.
16. LH side: Attach the washer reservoir wiring harness.
^
Connect the washer jet hoses.
^
Connect the electrical connectors.
17. LH side: Attach the engine compartment ground cables.
^
Secure the clips.
^
Tighten the nuts to 25 Nm (18 ft. lbs.).
18. LH side: Connect the ABS electrical connector.
19. LH side: Attach the air suspension pipes.
^
Secure the clips.
20. LH side: Attach the body panel ground cables.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
21. LH side: Connect the body panel electrical connectors.
Vehicles with auxiliary climate control
1. LH side: Secure the A/C lines to the body panel.
^
Tighten the nut to 10 Nm (7 ft. lbs.).
All vehicles
1. LH side: Connect the adaptive front lighting control module electrical connector.
2. LH side: Connect the washer jet hose.
3. Passenger side: Connect the transfer case electrical connector.
4. Passenger side: Connect the engine wiring harness electrical connector.
5. Install the headlamps.
6. Install the fender splash shields.
7. Attach the BJB wiring harness to the bulkhead.
^
Connect the electrical connectors.
^
Install the grommet.
8. Install the battery ground cable.
^
Attach the additional ground cable.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
9. Secure the BJB to the bracket.
^
Tighten the bolt to 6 Nm (4 ft. lbs.).
10. Connect the heater motor electrical connector.
11. Connect the ground cables to the lower A-pillar.
^
Tighten the nut to 10 Nm (7 ft. lbs.).
12. Install the CJB bracket.
^
Tighten the nuts to 10 Nm (7 ft. lbs.).
^
Secure the clips.
^
Connect the electrical connectors.
