landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Suspension - Warning Indicator(s) ON/DTCs Set|Page 1810 > < Suspension - Warning Indicator(s) ON/DTCs Set|Page 1808
Page 3
background image

3.

Remove the delivery valve-retaining plug. (Figure 2)

4.

Remove and discard the return spring and delivery valve.

5.

Install a new 0-ring seal to the delivery valve-retaining plug.

6.

Install the new spring and delivery valve into the compressor.

^

Tighten the delivery valve-retaining plug to l2Nm (8.8 lbf ft).

7.

Remove plugs in the inlet and outlet connections.

8.

Refer to Workshop Manual (GTR) section 204-05, Vehicle Dynamic Suspension, and install the new air suspension system compressor drier.

UPDATE THE RIDE LEVEL CONTROL MODULE SOFTWARE

CAUTION:

Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the vehicle.

CAUTION:

A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during IDS diagnosis / module programming.

1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.

2.

Turn ignition ON (engine not running).

3.

Verify air suspension system compressor is not running.

^

If the compressor is running, use the Integrated Diagnostic System (IDS) for Diagnostic Trouble Codes (DTC) and rectify as necessary.

^

If the compressor is not running, continue to step 4.

NOTE:

IDS must be loaded with IDS-DVD119_V8.03 or later and Calibration File 21 or later.

4. Connect the IDS to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.

5. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.

6. From the Session Type selection screen, choose 'Diagnosis'.

7. Select the Selected Symptoms tab, and then select:

^

Chassis > Suspension system > Vehicle dynamic suspension

8. Select 'continue'.

9. Select the Recommendations tab.

10. From the Recommendations tab, select Run to configure the Ride level control module

^

Follow all on-screen instructions to complete this task.

11. Exit the current session.

12. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.

Suspension - Warning Indicator(s) ON/DTCs Set|Page 1810 > < Suspension - Warning Indicator(s) ON/DTCs Set|Page 1808