landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Restraints - DTC's B1213-1B/B1212-1B/B0072-1B/B0070-1B|Page 1745 > < Restraints - DTC's B1213-1B/B1212-1B/B0072-1B/B0070-1B
Page 2
background image

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always
refer to DDW to obtain the latest repair time.

The labor times listed are for rectification of the DTCs noted above and are not to be used for instances of harness replacement.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

REPAIR PROCEDURE

ROUTE AND SECURE PRETENSIONER HARNESS FOR MANUAL ADJUSTING SEAT

WARNING:

The safety precautions detailed in the Workshop Manual relating to Supplementary Restraint Systems (SRS) must be adhered to.

NOTE:

Where a procedure refers to a 'cable tie' only, the edge-clip is to be removed from the cable tie/edge clip assembly and discarded. Where a procedure
refers to installing an 'edge clip' the clip provides a 'mount' for the cable tie.

1. Refer to Workshop Manual 501-10: Front Seat> Removal and Installation > Front Seat, and remove the affected front seat.

2. Release the pretensioner wiring harness and disconnect the connector from the seat frame.

CAUTION:

Care must be taken to avoid damage to the pretensioner wires. The wires must face away from the inboard side of the seat when secured by the
cable ties. The cable ties must not be over-tightened. (Figure 1)

3. Route the pretensioner wiring along the side of the pretensioner tube so that the wiring is facing away from the inboard side of the seat. (Figure 1)

4. Secure the wiring with a cable tie at point A, ensuring not to over-tighten the cable tie. (Figure 1)

5. Using black fabric tape, secure the wiring to the pretensioner tube, ensuring the tape does not extend beyond the end of the tube. (Arrowed in Figure

1)

6. Secure the wiring with a cable tie at point B, ensuring not to over-tighten the cable tie. (Figure 1)

CAUTION

The under-seat connector must not be under any strain.

7. Connect the under-seat connector, ensuring the connector is not under any strain.

Restraints - DTC's B1213-1B/B1212-1B/B0072-1B/B0070-1B|Page 1745 > < Restraints - DTC's B1213-1B/B1212-1B/B0072-1B/B0070-1B