LR3 (LA) V8-4394cc 4.4L (2005)
The exact "TARGET SPECIFICATION" in the table shown should be used on vehicles that have experienced uneven tire wear.
When setting suspension geometry after front or rear/upper or lower control arm bushing replacement, the rear toe should be set to the TARGET
SPECIFICATION in the table.
3.
Refer to GTR section 204-00 Four-Wheel Alignment operation 57.65.04 and adjust the front and rear wheel alignment to the TARGET
specification figures noted in the table above.
Disclaimer
Technical Service Bulletin # TECLTB00116
Date: 080226
Suspension/Steering - Uneven Tire Wear
No.: LTB00116
Issue: 1
Date: 26 FEB 2008
THIS BULLETIN REPLACES LA204-005, ISSUE 3. CHANGES ARE HIGHLIGHTED WITH GRAY BACKGROUND AND ASTERISKS.
SECTION: 204-00
Uneven Tire Wear - Repair Procedure
AFFECTED VEHICLE RANGE:
LR3 (LA)
VIN: 5A000360 - 6A403382
Model Year: 2005 - 2006
CONDITION SUMMARY:
UNEVEN TIRE WEAR
Situation:
A customer may report a concern of uneven tire wear. The steering alignment geometry of certain vehicles may experience some bushing settlement
during early vehicle life. Following initial production geometry setting, this settling may alter the geometry settings outside of normal tolerance, which
may in turn increase tire wear.
Revised geometry settings introduced after 6A403382 compensate for this situation.
NOTE:
This situation is not experienced on all vehicles. Toe sensitivity may be attributed to other factors.