LR3 (LA) V8-4394cc 4.4L (2005)
8. Raise the RH side of the engine by approximately 40 mm.
^
Use a transmission jack.
^
Remove the 2 bolts.
9. Remove the fluid pan.
^
Position a container to collect the fluid spillage.
^
Remove the 21 Torx screws.
^
Remove and if necessary, discard the seal.
^
Discard the O-ring seal.
Installation
1. Install the fluid pan.
^
Clean the components.
^
Install the seal.
^
Install a new O-ring seal.
^
Tighten the Torx screws to 8 Nm (6 ft. lbs.).
2. Lower the RH side of engine.
^
Remove the engine support.
^
Tighten the bolts to 45 Nm (33 ft. lbs.).
3. Install the transmission heat shield bracket.
^
Tighten the 4 bolts to 10 Nm (7 ft. lbs.).
^
Connect the selector cable to its abutment bracket.
4. Install the transmission heat shield.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
5. Install the exhaust system.
6. Install the battery compartment side wall.
7. Refill the transmission with fluid.