Workshop Manuals Factory service & repair Land Rover
01 Introduction02 Key information03 Sequential multiport fuel injection (SFI-V8)04 Diesel05 Starting and charging06 Cruise control07 Transfer gearbox08 Automatic gearbox09 Ignition and shift interlock10 Anti-lock brake system11 Data link connector12 Instruments13 Warnings and indicators14 Horns15 Radio16 Wash/wipe17 Heated front screen18 Heated rear screen19 Electrochromic rear view mirror20 Headlamps21 Side lamps22 Stop lamps23 Direction indicator lamps24 Reversing lamps25 Fog guard lamps26 Interior lamps27 Cigar lighter/clock28 Heating and ventilation (without A/C)29 Heating and ventilation (WITH A/C)30 Power windows31 Sunroof32 Power seats33 Power mirrors34 Memory seats35 Heated seats36 Memory mirrors37 Trailer auxiliary socket38 Air suspension39 Security/central locking40 Power distribution41 Fuse details42 Ground distribution43 Component location table44 Component location views45 Connector views46 Harness routing
Land Rover Range Rover P38 Electrical Troubleshooting Manual (1997-1999)39 · Security/central locking
39 · General

Security/central locking – circuit operation

Make
Land Rover
Model
Range Rover P38 Electrical Troubleshooting Manual
Year
1997–1999
Section
Circuit operation › Security/central locking – circuit operation
Security/central lockingSecurity/central locking – circuit operation

SECURITY/CENTRAL LOCKING – CIRCUIT OPERATION

Lazy Locking

Lazy locking can be carried out when either locking or superlocking, or when the vehicle is already in a locked state, by either holding the key turned to the lock position or by holding the remote handset lock button pressed for more than one second. This will cause all the open windows to start closing simultaneously. Closure of the windows will be followed by closure of the sunroof. Dependent upon market requirements, lazy locking will either operate in one-shot mode, or in dead man’s handle mode. In one-shot mode, the windows and sunroof will  continue to close even after the key has been released from the lock position, or the lock button on the remote handset has been released. In dead man’s handle mode, closure of the win dows and sunroof will only continue for as long as the key is held to the lock position, or the lock button is pressed on the remote handset. In this case, failure of any of the apertures to be fully closed upon release of the key/button will result in a mislock.

Mislock

A mislock condition is indicated by either two short “beeps” from the alarm sounder, or by three short flashes of the courtesy lights, depending on the market legislation.

Partial Arming Of The Perimetric Alarm

If the perimetric alarm is armed with one (or more) of the doors, or the tailgate, or the bonnet open, then the remaining panels are all protected by the alarm. If any of the open panels are subsequently closed, then they too will be protected by the alarm.

Security LED

The security LED has two functions: Firstly for the initial ten seconds after a lock re quest, it provides visual confirmation of the lock status. Secondly, after this confirmation period, it acts as  a deterrent to any theft attempt, (flashing at a slower rate).

Volumetric Protection

Volumetric protection, (protection of the vehicle’s interior), is provided by an Ultrasonic Sensor and an Ultrasonic detector . If the vehicle has been successfully superlocked with the key, then provided all the windows are closed, a

single press on the remote transmitter lock button will activate the ultrasonics. There is a 5 second settling period before movement can be detected.

Parts & tools for this job For 1997 Land Rover Range Rover

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.