Range Rover P38
12
ENGINE
NEW RANGE ROVER
2
REPAIR
Refit
10. Clean seal register and crankshaft pulley.
11. Lubricate outer face of seal.
12. Using LRT-12-089, fit seal to cover.
13. Lubricate oil seal lip. Fit crankshaft pulley.
14. Refit crankshaft pulley bolt. Tighten to
270 Nm
(200 lbf.ft)
15. Ensure mating faces between flywheel access
cover and gearbox are clean.
16. Lower vehicle.
17. Ensure mating faces between water pump pulley
and pump are clean.
18. Refit water pump pulley. Tighten to
22 Nm (16
lbf.ft)
19. Refit alternator drive belt.
20. Refit cooling fan.
See COOLING SYSTEM,
Repair.
21. Reconnect battery negative lead.
CRANKSHAFT PULLEY AND FRONT COVER OIL
SEAL - from 99MY
Service repair no - 12.21.01 Crankshaft pulley
Service repair no - 12.21.14 Front cover oil seal
Remove
1. Remove auxiliary drive belt.
See ELECTRICAL,
Repair.
2. Secure LRT-12-080 to crankshaft pulley with 2
bolts.
3. Remove crankshaft pulley bolt.
4. Remove crankshaft pulley.
5. Using LRT-12-088, remove oil seal from front
cover.
Refit
6. Clean seal register in front cover and crankshaft
pulley.