Range Rover (LM) V8-4.2L SC (2006)
Yaw Rate Sensor: Service and Repair
Yaw Rate Sensor
Service Repair No - 70.70.35
Removal
1. Disconnect the negative battery cable
2. Remove the auxiliary heater core and evaporator core housing
3. Remove the yaw rate sensor
^
Disconnect the electrical connector
^
Remove the 2 bolts
Installation
1. Install the yaw rate sensor
^
Install the 2 bolts and tighten to 7 Nm (5 ft. lbs.)
2. Install the auxiliary heater core and evaporator core housing
3. Connect the battery ground cable