Range Rover (LM) V8-4.2L SC (2006)
12. Remove the camshaft sprockets.
^
Remove the 2 bolts.
13. Remove the special tool from the RH cylinder head.
^
Remove the 3 bolts.
CAUTION: Evenly and progressively, release the camshaft bearing caps.
NOTE: Remove the camshaft bearing caps. Note their position, orientation and markings, each is marked with its position (number) and an
orientation (arrow).
14. Remove the camshaft bearing caps.
^
Remove the 20 bolts.
15. Remove the camshafts.
Installation
1. Check and adjust the valve tappet clearances.
2. Replace the valve tappets, with the smallest tappet available.
^
Apply a light coat of clean engine oil to the replacement valve tappets.
3. Install the camshafts.
^
Clean the component mating faces.
^
Lubricate the journals and camshaft lobes.