Range Rover (LM) V8-4.2L SC (2006)
6. Remove the ABS module.
^
Loosen but do not remove the 2 nuts.
^
Release from the locating grommet.
Installation
1. NOTE: Make sure the ABS module locating grommet is correctly seated in the bracket before installing the ABS module.
NOTE: Make sure the ABS module locating pin is correctly located in the grommet, and the 2 isolators are fully seated in the bracket slots.
Install the ABS module.
^
Tighten the nuts to 8 Nm (6 ft. lbs).
^
Tighten the M10 and M12 unions to 15 Nm (11 ft. lbs).
^
Tighten the M14 union to 17 Nm (13 ft. lbs).
2. Connect the electrical connector.
^
Secure the latch.
3. Install the engine cover.
4. Using T4, bleed the braking system.