Range Rover (LM) V8-4.2L SC (2006)
Clutch Pressure Regulating Solenoid: Service and Repair
Transfer Case Clutch Solenoid
Service Repair No - 41.30.08
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. CAUTION: Connect T4, prior to removal of the solenoid.
NOTE: Some fluid spillage is inevitable during this operation.
Remove the transfer case clutch solenoid.
Position a container to collect the fluid spillage.
Remove the 3 Torx(R) screws.
Use T4 to energize the solenoid.
Detach from the selector lever.
Disconnect the electrical connector.
Installation
1. CAUTION: Make sure the seal is installed correctly.
Install the transfer case clutch solenoid.
Clean the components.
Connect the electrical connector.
Use T4 to energize the solenoid.
Install to the selector lever.
Tighten the Torx(R) screws to 6 Nm (4 ft. lbs).
2. Check and top-up the transfer case fluid level.
3. Using T4, calibrate a new transfer case control solenoid.