Range Rover (LM) V8-4.2L SC (2006)
Gear Sensor/Switch: Service and Repair
High/Low Range Sensor
Service Repair No - 41.30.07
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the transmission support insulator nut, bolt and damper.
Support the transmission.
3. CAUTION: To avoid damage to the joints or gaiters, do not allow the transmission to hang on the driveshafts.
Remove the high/low range sensor.
Lower the transmission.
Disconnect the electrical connector.
Remove the 2 Torx(R) bolts.
Installation
1. Install the high/low range sensor.
Clean the components.
Tighten the Torx(R) bolts to 6 Nm (4 ft. lbs).
Connect the electrical connector.
2. Install the transmission support insulator nut, bolt and damper.
Tighten the bolt to 115 Nm (85 ft. lbs).
3. Using T4, calibrate a new high/low range sensor.