Range Rover (LM) V8-4.4L (2009)
25. NOTE: Left-hand shown, right-hand similar.
Remove the floor console LH finisher trim panel.
^
Remove the 11 screws.
26. Remove the floor console RH finisher trim panel.
^
Remove the 11 screws.
27. Remove the 14 clips from the floor console.
28. Remove the 2 brackets from the floor console.
^
Remove the 2 screws.
Installation
1. Install the 2 brackets to the floor console.
^
Install the 2 screws.
2. Install the 14 clips to the floor console.
3. Install the floor console LH finisher trim panel.
^
Install the 10 screws.
4. Install the floor console RH finisher trim panel.
^
Install the 10 screws.
5. Install the rear auxiliary climate control assembly.
^
Connect the 2 electrical connectors.
^
Install the 4 screws.
6. Install the floor console rear trim panel.
^
Install the 4 screws.
7. Connect the 6 electrical connectors to the rear passenger entertainment control panel.
8. Install the floor console upper panel.
^
Connect the 3 electrical connectors.
^
Attach the 3 wiring harness clips.
9. Connect the parking brake switch electrical connector.
10. Reposition the floor console upper panel.
^
Secure the 4 clips.
^
Install the 4 screws.
11. Install the center console LH side finisher trim panel.
^
Secure the 3 clips.
12. Install the center console RH side finisher trim panel.
^
Secure the 3 clips.
13. Install the floor console stowage compartment.
^
Connect the cigar lighter electrical connector.
^
Secure the 2 clips.
^
Install the 2 screws.
^
Close the floor console stowage compartment lid.
14. Install the cellular phone cradle assembly.