Range Rover (LM) V8-4.4L (2009)
Trim Panel: Service and Repair
Pillar Trim
A-Pillar Trim Panel
A-Pillar Trim Panel
Service Repair No - 76.13.26
Removal
WARNING: The air bag is mounted directly under this component, extreme care is necessary.
1. Release the door aperture weatherstrip for access.
2. Release the screw cover.
^
Remove the Torx screw.
3. Remove the A-pillar upper trim panel.
^
Carefully release the 2 clips.
4. NOTE: Do not disassemble further if the component is removed for access only.
Remove the 2 clips.
Installation
1. Install the clips.
2. Install the A-pillar upper trim panel.
CAUTION: Make sure the Torx screw is not over tightened. Failure to follow this instruction will result in damage to the vehicle.
Install the door aperture weatherstrip.
^
Secure the clips.
^
Tighten the Torx screw to 2 Nm (1.5 ft. lbs.).
^
Install the screw cover.
^
Install the door aperture weatherstrip.
B-Pillar Trim Panel
B-Pillar Trim Panel
Removal
WARNING:
^
Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^
The correct procedures must always be used when working on SRS components.
^
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse
connect the battery.
^
Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^
The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^
Do not probe supplemental restraint system (SRS) electrical connectors.
^
Take extra care when handling SRS components.